Question:I’m building an entertainment center and using 10 mil paperbacked Walnut veneer over MDF. I have seen DITY advice on the Internet saying that it’s necessary to veneer both sides of the MDF. I … read more

Question:I have recently constructed a table top. It’s approximately 8 ft by 4 ft with a 3 inch deep edge all the way around. I’ve made it very solid, and it’s perfectly sanded and even all over.I am … read more

Question:I have a veneered hope chest by Lane Furniture that is 60-70 yrs old. It was my mother-in-law’s and it was her mother’s before that. The veneer itself seems to be fine (meaning it isn’t buckl … read more

Question:I just bought a new house and want the stairs to look 100% wood. At this point, each step is made of ash, but the riser is just painted white on an unknown type of wood. In all your products, … read more

Question:I would like to veneer the side of a table but it is rounded. Is it possible to do this? Or do you always need a straight surface?Answer:Are you inquiring about veneering the “apron’” of the … read more

Question:I recently purchased 10ML Paperbacked Jatoba veneer sheets but have only used pre-glued sheets in the past. What is the recommended way to apply the 10ML Paperbacked sheets to 1/2″ Birch Ply? … read more